TY - GEN
T1 - Compression moulding of a recycled carbon fibre reinforced epoxy composite
AU - Wong, Kok H.
AU - Pickering, Stephen J.
AU - Turner, Thomas A.
AU - Warrior, Nicholas A.
N1 - Copyright:
Copyright 2010 Elsevier B.V., All rights reserved.
PY - 2009
Y1 - 2009
N2 - High strength carbon fibre was recycled from aerospace epoxy composite scrap using a pyrolysis process. The feasibility of using the recycled fibre in a non-woven form for a flame-retardant epoxy was investigated. Single fibre tensile tests and SEM analysis were used to determine the quality of the recycled fibre. No significant change in the tensile properties of the fibre was seen and the fibres generally had a clean surface. The recycled fibre was converted into a non-woven mat using a wet process. The mat was then compression moulded with resin film into a plaque to give fibre volume fractions ranging from 20 to 40%. The mechanical performance of the plaques was then analysed. A positive linear relation between stiffness and fibre volume content was observed. However, the contribution to composite strength with increasing fibre volume content was less significant due to the degradation in fibre length during the high-pressure compression moulding process.
AB - High strength carbon fibre was recycled from aerospace epoxy composite scrap using a pyrolysis process. The feasibility of using the recycled fibre in a non-woven form for a flame-retardant epoxy was investigated. Single fibre tensile tests and SEM analysis were used to determine the quality of the recycled fibre. No significant change in the tensile properties of the fibre was seen and the fibres generally had a clean surface. The recycled fibre was converted into a non-woven mat using a wet process. The mat was then compression moulded with resin film into a plaque to give fibre volume fractions ranging from 20 to 40%. The mechanical performance of the plaques was then analysed. A positive linear relation between stiffness and fibre volume content was observed. However, the contribution to composite strength with increasing fibre volume content was less significant due to the degradation in fibre length during the high-pressure compression moulding process.
UR - http://www.scopus.com/inward/record.url?scp=74949095632&partnerID=8YFLogxK
M3 - Conference contribution
AN - SCOPUS:74949095632
SN - 9781934551059
T3 - International SAMPE Symposium and Exhibition (Proceedings)
BT - SAMPE '09 Spring Symposium Conference Proceedings
T2 - SAMPE '09 Spring Symposium Conference Proceedings
Y2 - 18 May 2009 through 21 May 2009
ER -